RE: Ask the Car Guy @socky March 30

You are viewing a single comment's thread from:

RE: Ask the Car Guy @socky March 30

View the full context

enforcer48 (68)in #life • 7 years ago

Yo dude!

I have a 2004 Hyundai Accent and I noticed that the pump for the washing fluid is not working. Well, I filled up the fluid, but when it comes to release it, it doesn't come out.

How do I tell if it's clogged or the pumping mechanism is broken? I would like to get an opinion before I do anything about it.

7 years ago in #life by enforcer48 (68)

Sort:

socky (72) 7 years ago (edited)

Steps

Open the hood and find the reservoir. Have someone operate the windshield fluid spray button inside the car while you listen for the pump to operate. It will hum.
a. If no noise, check for a bad fuse.
b. if fuse is good, the pump motor is likely bad. These new reservoirs often come with a pump. If you have a voltage meter, you can disconnect the wires to the reservoir and check for power when the spray button is pressed. If you don't have a meter, you will just have to replace the reservoir/pump and hope that it is not a wiring issue.
If the pump is working, you can unclog a nozzle with a needle.
If that doesn't work, pull the hose off the back side of the nozzle and press the windshield spray button. If no fluid comes out of the hose, then the pump is likely bad
If fluid comes out of the hose and the needle trick didn't work, you can use a pair of pliers to unclip the nozzle from the hood. You can soak the nozzle in vinegar to clear the nozzle or just replace it.

$4.63

4 votes

[-]

enforcer48 (68) 7 years ago

Thanks! I'll give it a shot.

$0.00