We make puppet theater for children (part 1)

in #art7 years ago (edited)

100_1855.JPG

1 часть-англ.jpg

To avoid breaks and splits, take wooden bars without knots! Choose carefully or take some extra bars for a case.

100_1740.JPG

100_1745.JPG

100_1755.JPG

Cut the bars with a jigsaw or saw in accordance to the dimensions specified in the chart.
9 pcs = 31 cm, 3 pcs = 66 cm, 6 pc = 120 cm
Grind the prepared bars with a sandpaper!
When the bars are cut and ground, proceed to assembly.
For assembly, you will need a corner ruler so that when you screw the bars together, the corners remain as straight as possible.
• Lay the bars on the floor in accordance with the plan.
• Take the outer corners and screw the bars together with short self-tapping screws
* There are peculiarities of the screwing! For the aelf-tapping screws that are closer to the edge: before they are screwed in, makes a hole on the length of the screw with a thin drill (No. 3) and then screw in the self-tapping screw (otherwise the bar can crack). The same should be done with long self-tapping screws that twist the end!
100_1774.JPG

100_1776.JPG

100_1782.JPG

• When all the frames are twisted together (we have 3 of them now), we begin to twist at the end the lateral screws (long). This is necessary for the strength of the structure. Here we also pre-drill the holes.

100_1780.JPG

100_1790.JPG

Put the ready frames on the floor and mark the place for the hinges; pre-drill the holes for the screws under the hinges, with a thin drill, then attach the loops and fasten them!

100_1793.JPG

100_18471.JPG

• After assembly, it is necessary to install the supports for each side (3 pieces), see the diagram.
On the lower bars of the frame in the middle with a drill No. 5 we make a through hole for the screws.

Take 3 bars of 31 cm, in the middle with a drill No. 5 we make a through hole for the screws.

On the lower part on one side with a large drill No. 18, make a small groove for the cap of the screw so that it remains on the same level with the bar surface after screwing!

100_1928.JPG

100_1927.JPG

Insert a screw - a spacer - the carcass bar - a spacer – a screw nut – a screw nut (see the assembly diagram) through the lower bar. Do not tighten the screw nuts too tight in order to facilitate the manipulations with the support.

100_1929.JPG

100_1938.JPG

100_18481.JPG

Cover the frame with an acrylic polish (100 ml). Paint the window with an acrylic paint.
At the edges of the window screw 2 self-tapping screws for the curtains and paint them with the white paint.

100_1796.JPG

100_1798.JPG

This completes the assembly of the wooden frame. ))))

.......to be continued ... part 2.


https://steemit.com/@nataliya.farkash
https://twitter.com/NatalineHM?lang=ru
https://www.facebook.com/nfarkash/
https://www.facebook.com/Nataliya.Farkash
https://www.livemaster.ru/topic/1555863-izgotavlivaem-kukolnyj-detskij-teatr?vr=1&inside=0