SLC S21W6-Basic patterns for men's trousers

If I have to draw basic pattern for men trouser front side then first of all the measurements that I need outer length, contour of waist, contour of hip and height of hip. I take a blank plain page at which I have drawn a rectangle which I labelled as A B C D.

If you have to measure height of then you need to measure length of AD point as I measured through a dotted line shown in picture which I took or extended to other end in between B C points.

I take measurements of hip 1/4th and add 4 cm in it at A D point. After that you can see 3 lines in which first line is 1 ,second line is line 2 and third line is 6.I have divided line number 2 with 15 percent after that I got around 2.9 cm. By measurement of 2.9 cm line 2 I am going to extend more outside rectangle.

After that I focus on AD point and move 2 cm below and mark that point as 4.I take 4th part of waist from A B point while making measurements. After that I marked a line by measurement 1/2th part from outer length.

Now from point CD I am introducing 2.9 cm.I match measurements of 2.9 cm from C to D and from D to C.All points have been marked!

Now it's a time to join all points wisely for getting front complete pattren for men trouser. I have joined point one with point 3 with a smooth curve shape for adding dart. At top of rectangle we can see that there are 4 and 5 that can be joined together with straight line.Side seam can be created by joining line 5 with line one. At last in finishing we will join line 3 with line 8 by using scale and line 7 with line to by using scale at both these are straight joinings.

If I have to draw basic pattern for back piece of trousers for men then again I need to make a rectangle with measurements that I have already taken in creation of my first piece rectangle. In rectangle above there were three lines which I mark as as first line point 2 as second line and 6 as third line. At bottom I also marked point 7.

About I have obtained 2.9 cm as my calculations results so I need to multiply it by 3 which is equal to 8.7 cm almost so I extend line to as I extend it above and extended line I mark as 3 but along with that extended line I created a dotted 8.7cm line along extended line which I mark as point number 9. I divided extended line in following marking which is 3,31 and 32. In this way that for back piece for men's trouser can be obtained.

I introduced 2 cm at A B point and move upward 2 cm there which I marked as it is point number 4.After this step I added 2 cm in 4th part of my measurements of waist.I created line in middle of point 4 and 5.

If I talk about point number 8 then it's same which can be seen in front pattren too.after that I need to take measurements of distance present in between line two and six. I started from point 3two to line 6 for giving it a curve and then I extended point number 3 in downward direction because now I have to join points together to giving a final look to my back trouser pattern for men.

First I have joined point 3 with 1 in curve shape. After that at top of rectangle point one can be seen which was joint with line number one.again at top of rectangle point 4 and 5 are present as they were also present in front pattern so I joined both of them by using scale in straight line. Point 5 is joined with point one in slightly curve shape. Now it's a time to give final look to back pattern by joining point to with 7 and 9 with 8 in straight line. So now my back pattern for men trouser is ready!

This is front and back pattern both are present in one frame.

I want to invite @ahsansharif,@sahar78,@suboohi,@stef1