Tubeless or not Tubeless, is it a question?!

in #cycling6 years ago

To go tubeless or not for your MTB bicycle tyres, that is a question some of you might ask yourselves. For me it's clear: the South African bush has so many thorns and sharp rocks, that tubeless is by far the best way to prevent punctures.

Screen Shot 2018-07-02 at 19.14.58.png
image source: mbr.co.uk

The advantages of tubeless tyres are:

  • reduces risk of punctures, especially pinch flats;
  • you can run lower pressures, which improves traction;
  • depending on the system you use, tubeless can be lighter than riding with tubes, and
  • better absorbation of shocks.

The disadvantages are:

  • You will need to maintain the sealant level, and it's hard to judge how much sealant is left;
  • you will have to buy tubeless ready rims with rim tape and tubeless ready tyres;
  • tubeless tyres can be a pain to install;

How to install tubeless tyres?
There is plenty of advice on the web on how to install tubeless tyres. Although some say you have to have a compressor or a special pump to install tubeless tyres, I usually just use my foot pump. Make sure the tyre doesn't show a big gap before you start pumping: distribute the tyre evenly around the rim, and have the wheel hanging, e.g. not on the ground with the tyre flattened.

If you smear the edge of the tyres close to the rims with some sealant, they normally fit easier. Make sure you wait until you hear a few big pops, that will tell you the tyre is installed properly. Put a lot of pressure in them and turn the tyre around (ideally for a few hours); the sealant will then be able to go everywhere where there is a little hole. Deflate to the right pressure when you start riding.

How to plug tubeless tyres?
I answered this in one of my of previous posts, and I have copied part of the text below. If you fail to plug the tyre with a plug, you will have to put your spare tube in. Make sure you remove all thorns and clean out your tyre first, and you have to remove the valve. If you have a side wall cut, you would have to carry a big patch that will hopefully hold after installing the tube.

Screen Shot 2018-05-28 at 08.23.55.png

When you get bigger holes that the sealant is not able to stop, you might need to plug your tires. There are a few plugging kits on the market, some fancier than others, some are really expensive, some come with glue, a small knife, some can fit in your handlebars, etcetera. What I use to plug my tires is this:

Screen Shot 2018-05-28 at 07.56.45.png

That’s all. It’s an insertion tool with plugs. You can actually install already one of the plugs, and wrap it in cling foil, ready to use. For longer rides I carry some extra plugs, perhaps some bigger plugs as well. You can carry a small knife as well, or e.g. a shaving blade, to cut of any excess plug that will stick out. What you have to do is: find the hole, insert the tool and make sure the plug is more or less halfway, then remove the tool, make sure the plug remains in the tire, and cut off (only some of) the plug sticking out so you have a slightly smoother ride, and that’s it!

Screen Shot 2018-05-28 at 07.54.35.png

@Ultrabiker

Click here for my other posts

Sort:  

In warm countries with a lot of thorny plants,it isn't a question. It is either tubeless or walking :D

tube-less or bike-less... ;-)

I've kind of had it with tubeless, too much of a hassle to maintain and setup. Have you ever had to put a tube in on the trail? It's a mess...

Plus the saying 'you can run lower pressure' is BS. Try going 15-20 mph on a turn with low tire pressure, it will 'fold' or roll on your rim so you have less control. You have tire 'squirm'.

Have you ever seen those FedEx mail envelopes that are made from Tyvek? I used to line the inside of the tire with that stuff to prevent flats. We don't have too many thorns around here, but did it after reading the tip years ago.

Well, if you have a choice, then that is great... Where we ride, we would have a flat tire after every 10 minutes. I'll look into that envelope, not sure if we have them here...

This is what they look like, I'm sure you have them as FedEx is a worldwide shipper. It's not 100% by any means, but much better than running nothing at all, plus it's very light compared to a thick liner.
I've purchased tires that have a kevlar lining, not sure if they make those for mtb tires.
tyvek.jpg

Thanks, yes have seen them, will have a look....