Repair Ront loader.

Hello everybody. was I at work decided to show you how the workers did the loader. Photographed on the phone samsung j 3.

LG956L FRONT LOADER.

Characteristics LG956L:

• Carrying capacity is 5000kg.

• Bucket capacity 3m3

• The width of the cutting edge is 3024mm.

• Control of working equipment joystick

• Max. height of unloading (on attachment of the loading bucket to the loader's arm) 4128mm.

• The unloading height (when the bucket is opened at an angle of 45 degrees, along the bottom edge of the bucket) is 3120mm.

• Travel speed 38kg / h

• Working pressure of hydraulic system 18MPa

• Stripping advantage 18000kg.

• Running time 11sec

• Maximum climbability 30

• Operating weight 16900kg.

• Engine Model WD10G220E13

• Engine power 162 (220)

• Type of gearbox planetary with switching under load, reversible

• Working brakes dry disk with pneumohydraulic drive for 4 wheels

• Refueling capacity / fuel tank 295L

• Capacity / Hydraulics 210L

• Refilling capacity / engine 20l

• Refueling capacity / transmission 45L

Loader LG956L has fulfilled its shift to "excellent", there were no problems. Today the driver came and could not get: when turning the key turns, but does not grasp! As if the fuel supply does not go ... What could be the reason for this behavior?

We checked the fuel level in the tank. It's all right.
We tried to pump the system with a fuel pump. At the same time, check to see if the system is airborne and whether there is any suction of air somewhere.
In order to check whether the fuel is delivered to the injectors, it is possible to loosen the supply fuel pipes and check whether the fuel starts to flow.
If fuel is not supplied, it is important to establish where it is "lost". In this case, inspect all filters in turn. If the fuel is "lost" after the injection pump, then it must be taken to the stand and checked. You can remove the lid and check if the plunger pairs of high-pressure pump

The cause was found. A system of air sucking up to the injectors was blown up. Changed the hose and filters and everything worked.