Overvolting a car ignition coil up to 90 kV!

in #science6 years ago

giphy.gif

In this video I am using a phase fired controller (PFC), also called phase angle controller I salvaged from a vacuum cleaner. Its main attribute is to reduce the effective voltage by chopping the waveform, hence reducing the power output.

Our coil takes advantage of the dead time between pulses, as it was design to work only with DC pulses. Each time a current pulse fires, the coil is energized and the magnetic field increases inside its core. When the pulse stops, the magnetic field collapses which makes the current to oppose the change. This creates a very high voltage spike across the secondary coil terminals which jumps over 3 cm of air. The breakdown voltage of air is 30 kv/cm which means this setup is generating 90 kV.

This very high voltage is too much for coil insulation to handle. As it was designed to work only with DC current, parasitic capacities are forming in AC operating mode, which causes the breakdown of dielectric in unwanted locations. I've tried hard to increase the dielectric strength by putting multiple layers of heat shrinking tube, but I only managed to delay the inevitable...
Although the transformer is driven directly from the mains voltage terminals I am limiting the current through a 122 ohms reactive capacity.

Watch full video below:

I hope you enjoyed watching, if you have any questions leave them in video comment section.

Subscribe for more awesome content to come.

Sort:  

Hello,

In order to confirm your authorship of the content, please make a mention about Steemit or add a hyperlink to Steemit in your YouTube vlog:

https://www.youtube.com/channel/UCnex2dmGLIoeRNc13RGz3SQ/about

You can remove this mention from your website, once we confirm the authorship.

Thank you.

More Info: Introducing Identity/Content Verification Reporting & Lookup

I added the hyperlink to my blog page.

Hello,

We have seen it. Thank you for verification.
You can remove it now.

Congratulations @electroscience!
Your post was mentioned in the Steem Hit Parade for newcomers in the following category:

  • Pending payout - Ranked 7 with $ 5,99

I also upvoted your post to increase its reward
If you like my work to promote newcomers and give them more visibility on the Steem blockchain, consider to vote for my witness!

Thank you for upvote. I gave you my vote as a witness.

Thank you for your support and witness vote @electroscience, really appreciated!

Sneaky-Ninja-Throwing-Coin 125px.jpg
Defended (14.08%)
Summoned by @electroscience
Sneaky Ninja supports @youarehope and @tarc with a percentage of all bids.
Everything You Need To Know About Sneaky Ninja


woosh

Resteemed by @resteembot! Good Luck!
Check @resteembot's introduction post or the other great posts I already resteemed.

You were lucky! Your post was selected for an upvote!
Read about that initiative
logo

Congratulations @electroscience! You have completed the following achievement on the Steem blockchain and have been rewarded with new badge(s) :

You received more than 10 as payout for your posts. Your next target is to reach a total payout of 50

Click here to view your Board
If you no longer want to receive notifications, reply to this comment with the word STOP

You can upvote this notification to help all Steem users. Learn how here!

Hi! I am a robot. I just upvoted you! I found similar content that readers might be interested in:
https://www.youtube.com/watch?v=mFY9jLsc4Xo

You got a 36.76% upvote from @joeparys! Thank you for your support of our services. To continue your support, please follow and delegate Steem power to @joeparys for daily steem and steem dollar payouts!